poltunit.blogg.se - Sound control big sur

#SOUND CONTROL BIG SUR INSTALL#
#SOUND CONTROL BIG SUR UPGRADE#
#SOUND CONTROL BIG SUR FULL#

Now, it needs to be checked to establish a remote session on 10.15. Screen Recording (affects remote connection) – The option is not available on macOS 10.14 Mojave.If not checked, files/folders of the remote Mac will not be shown in the file transfer window. Now, it needs to be checked to use File Transfer on 10.15.

#SOUND CONTROL BIG SUR FULL#

Full Disk Access (affects file transfer) – The option is available on macOS 10.14 Mojave but does not need to be checked.

If this setting was done in Mojave before upgrading to Catalina, you may need to delete (-) the Accessibility setting for Splashtop Streamer, then re-add (+) and check it.

For new streamer installs on 10.15, this setting needs to be checked so remote control is enabled.

#SOUND CONTROL BIG SUR UPGRADE#

For OS upgrade cases, if you already have the option checked on 10.14, you don’t need to configure it again on 10.15.

Accessibility (affects control) – The option is available on macOS 10.14 Mojave and needs to be checked to enable remote control.

Users have reported that this action prompts the permissions to reset if they weren't working before. Note that these security settings cannot be configured remotely - you must change these settings once locally before being able to establish a remote session.Īlso, please note that if these are already checked, uncheck and recheck them. This new release has stricter security requirements that require explicit permission to allow applications to have control.įor Mac Streamer v3.3.2.0, these are the additional Security and Privacy settings that are required to be set to allow the Splashtop software to provide remote access:įour options under System Preferences / Security & Privacy / Privacy need to be checked for a remote session to work normally. Please see the FAQ for step by step installation instructions.Apple released macOS 10.15 Catalina on October 7, 2019.

#SOUND CONTROL BIG SUR INSTALL#

To install this driver on a Macintosh with an Apple Silicon processor, kernel extensions must be enabled manually in recovery mode. Added support for Apple Silicon platform. This driver only supports Big Sur and will not function on any previous macOS operating system.Ģ. Changed “Auto” Payload size to 32 on Apple Silicon platform.ġ. Fixed issue where interrupts might be missed if NControl is running at same time as streaming.Ģ. Fixed issue where unplug or power off of Thunderbolt device would cause kernel panic on Apple Silicon Macintosh on macOS 12 Monterey (worked properly on Intel Big Sur/Monterey and Apple Silicon Big Sur).ġ. Includes NControl 1.0.7.6 which now has MIDI Control Surface support.ġ.

Lynx Mixer “Rate Select” now changes with “Measured Rate”.ģ. Non-DMA V2 firmware is not supported on Apple Silicon based computers (must use AES16e firmware 14.1).Ģ. Fixed issue for Intel build that caused a kernel panic when using non-DMA V2 firmware (AES16e: Firmware 12.11 or older). ►Failure to follow the installation instructions may result leaving your computer in a state where the driver cannot be installed.◄ġ. ►It is imperative that you completely read the step by step installations instructions all the way through before installing the driver. ◄ Released: MaSystem requirements: macOS 11 Big Sur - macOS 13 Ventura